0

Milwaukee Impact Wrench Repair – Replacing the Gearcase (Milwaukee Part # 28-50-0060)


“The front gear case houses and supports your
impact wrenches anvil assembly. The gear case comes with the anvil bushings
already installed. After years of use the bushings can wear causing
play in the anvil. If the tool is dropped the gear case could
be cracked. Replacing the front gear case is a repair
that you can do yourself and I’m going to show you how. Hi I’m Mark Sodja. Do it yourself repairs like these are easier
than you might think. From lawn machines to cordless drills, kitchen
mixers, outdoor drills, our how-to videos walk you through each repair from start to
finish so doing it yourself means never having to do it alone. Let’s get started. I’ll begin by removing the front gear case. I’ll remove the anvil from the gear case. Now I can begin installing the new gear case. There’s a seal that I’ll need to transfer
from the old gear case to the new. I use my pick to remove it and transfer it
to the new gear case. Now install the anvil on to the gear box. I’ll make sure I offset the ears on the anvil
with the hammers on the gear box. I’ll reinstall the gear case sliding it over
the handle and aligning it with the housing and I’ll secure it with the screws. That’s how easy it is to replace the front
gear case on your impact. Be sure to check back often for new videos
and expert advise. If you found this video helpful give us a
thumbs up and leave a comment.”

Bernard Jenkins

Leave a Reply

Your email address will not be published. Required fields are marked *